22115 Autoloader 2 ALE2: Stage move command given destination beyond away. ThermoFlex If this is in response to a diagnostic command then adjust the target position to a valid value (ie. less than al hsap) and operation should resume as normal. If this is reported during requlard operation then it is likely that during a stage zero the media and surface reflectivity do not match resulting in a "runaway" condition. In this case, double check that the correct media is selected using "mode media #" where # is for the media you're using. Then check that the surface reflectivity is also correctly set. None. What it says - the stage has been asked to move to a position closer to the drum than it's known away position (stored in al hsap). ../nvs/al_cal_hsap.xmlNVS: al hsap ../nvs/media_cal_sr.xmlNVS: media sr ../commands/mode_media.xmlCommand: mode media ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:56 2008 PST